BPMMT - PR-1321-B, POLYSULFIDE SEALANT ACCELERATOR

Product Identification

Product ID:PR-1321-B, POLYSULFIDE SEALANT ACCELERATOR
MSDS Date:06/26/1990
FSC:8030
NIIN:01-303-2152
Kit Part:Y
MSDS Number: BPMMT

Responsible Party
PRODUCTS RESEARCH & CHEMICAL CORP
5430 SAN FERNANDO RD
GLENDALE, CA 91209
US

Emergency Phone: 800-228-5635;800-424-9300(CHEMTREC)

Info Phone: 818-240-2060

Preparer: A.S.

Cage: DO563

Contractor
PRODUCTS RESEARCH & CHEMICAL
1800 GLENDALE, CA 91209 US

Telephone: 818-240-2060

Cage: DO563

Ingredients

LEAD DIOXIDE

CAS: 1309-60-0

RTECS: OG0700000

Fraction By Weight: 75%

OSHA PEL 0.05 MG/M3 (MFR)

ACGIH TLV: 0.15 MG/M3 (MFR)

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:THE MOST SIGNIFICANT HEALTH HAZARD OF
LEAD DIOXIDE IS BY INHALATION OF AIRBORNE DUST PARTICLES. IN THIS
PRODUCT, LEAD DIOXIDE IS THOROUGHLY & PERMANENTLY WETTED, &
THEREFORE DOES NOT PRESENT RISK OF EXPOSURE TO DUST PARTICLES.
HOWEVER, INORGANIC LEAD COMPOUNDS IN GENERAL ARE TOXIC BY
INGESTION, (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:ALTHOUGH NOT READILY ABSORBED. ANEMIA,
CNS EFTS, ABDOMINAL COLIC OR KIDNEY FUNCTION LOSS CAN OCCUR AT
BLOOD LEAD LEVELS OF 60 UG/100 G. RECOMMENDED MAXIMUM IS 40 UG/100
G.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:EYES:IMMEDIATELY FLUSH W/WATER FOR AT LEAST 15 MINUTES. IF
IRRITATION PERSISTS, CALL MD. SKIN:WASH THOROUGHLY W/SOAP & WATER.
INHAL:REMOVE TO FRESH AIR. SUPPORT BREATHING (GIVE O*2/ARTF RESP) .
INGEST:CALL MD.

Fire Fighting

Flash Point:NON-FLAMMABLE
Extinguishing Media:WATER.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:OXIDIZER.

Accidental Release

Spill Release Procedures:SCOOP UP SPILLED MATERIAL. CLEAN UP RESIDUE
W/RAGS & NON-FLAMMABLE SOLVENT.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:AVOID INGESTION.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

Exposure Controls

Respiratory Protection:USE NIOSH/MSHA APPROVED RESPIRATOR APPROPRIATE
FOR EXPOSURE OF CONCERN .
Protective Gloves:OIL RESISTANT GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING & BEFORE SMOKING
OR EATING.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

Chemical Properties

Spec Gravity:2.6
Solubility in Water:NEGLIGIBLE
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:0

Stability

Stability Indicator/Materials to Avoid:YES
UNKNOWN.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:SMOKE, SOOT, CO, CO*2, LEAD COMPOUNDS.

Disposal

Waste Disposal Methods:DISPOSE OF IN COMPLIANCE W/FEDERAL, STATE &
LOCAL REGULATIONS. EPA HAZARDOUS WASTE NO:D008.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.